Skip to content

A photo report of your roof, and what to tend first

(919) 237-9586
(919) 237-9586

ServicesGutters

Gutters in Oxford, NC

Gutters work quietly until the day they don't. We clean, re-hang, repair and replace gutter systems so runoff is carried off the roof and released clear of your foundation. You get photos of what we find and only the work your gutters really need.

Worker on an aluminum ladder drilling along the white gutter and fascia of a brick ranch house, with a gutter section, tool bag and box on the lawn

A small system that protects a lot

A single inch of rainfall on a typical roof adds up to hundreds of gallons, all funneled to a handful of downspouts. When a run sags, clogs or pulls off the fascia, that water pours over the edge, soaks the trim and collects against the foundation. The damage builds slowly and is hard to spot from the ground.

Most gutters can stay in service for years with the right upkeep: resealed corners, new hangers, a corrected slope and a downspout that discharges where it should. We look closely at the existing system before suggesting replacement, and when replacement is the better call, we show you why with photos.

Gutters and roof edges wear out together, so we check the drip edge, fascia boards and lowest shingle courses on every visit. If something there needs work, we will say so and point you to our roof repair service rather than fold it into a gutter quote.

What our gutter work covers

Cleaning and flushing
We clear leaves, pine needles and shingle grit by hand, then flush each run and downspout to confirm water moves freely. Debris is bagged and hauled off, not left in your beds.
Re-pitching and re-hanging
A gutter needs a steady fall toward its outlet, about a quarter inch every ten feet. We reset sagging sections and swap loose spikes for hidden hangers fastened into solid wood.
Leak and seam repair
Corners and end caps are where older sectional gutters tend to leak. We clean the joint to bare metal and reseal it with a gutter-grade sealant that flexes with temperature swings.
One-piece gutter installation
When a system is beyond saving, we form new gutters on site from aluminum coil, each cut to the full length of its roof edge with no joints along the run. We size them to your roof, often moving from 5-inch to 6-inch K-style with larger 3x4 downspouts on steep or broad roofs.
Gutter guards
Homes under oaks and pines fill gutters quickly. We fit guards matched to the debris you actually get, since fine pine needles need a different screen than broad leaves.
Downspouts and drainage
We add extensions, splash blocks or rerouted outlets so water lands several feet from your foundation instead of right beside it.

When your gutters are asking for help

  • Rain sheeting over the edge

    If water pours past the lip during ordinary rain, the cause is usually a blockage, a run pitched the wrong way or a gutter too narrow for the roof feeding it.

  • Streaks or flaking paint on trim

    Dark lines down the fascia or soffit tell you water is getting behind the gutter. Over time it weakens the very boards the gutter is fastened to.

  • Dips and gaps along a run

    A section that bows between hangers holds standing water, and the added weight loosens it a little more each year.

  • Eroded ground beneath

    Channels cut into the mulch, mud spattered on the siding or dampness in the crawlspace often mean a downspout is dumping water right against the foundation.

  • Seedlings sprouting up top

    Small plants in a gutter show that wet debris has been sitting there long enough to break down. That held moisture wears out both the gutter and the roof edge over it sooner.

What happens on a gutter visit

  1. 1

    A close look, with photos

    We go around the full perimeter, get up to every run and look at the shingles and drip edge right above it. You then receive a photo report showing what needs work and what is still in good shape.

  2. 2

    Clear options, your call

    We lay out whether the system needs cleaning, repair or replacement, and each item appears on its own line so you can pick what to do. No work begins without your go-ahead.

  3. 3

    The day of the work

    Cleanings and repairs usually wrap up within a few hours, while replacing a typical house with one-piece gutters generally fills a single day. Our ladders sit on protective pads, and we drape tarps over plantings beneath the work.

  4. 4

    Flow check and haul-away

    As a final step, we send water down each run to make sure the slope is right and every outlet drains freely. We take the old metal, spent fasteners and debris away with us.

Roofer shows a homeowner photos of damaged shingles on a tablet in the driveway while a crew member works on the roof of a brick ranch home.

What shapes the cost of gutter work

Most of the price comes down to linear footage and the state of the wood behind the gutter. We measure on site and list each piece of work on its own line, so every dollar has a clear purpose. Financing is available through Acorn Finance for larger replacements.

Length and number of runs
A longer roof edge needs more gutter, more hangers and more downspouts. Inside and outside corners add labor too.
Height and access
A second-story eave, a steep pitch or a narrow side yard means more ladder setup and slower work than a one-level ranch.
Fascia condition
Rotted fascia has to be replaced before a gutter can be hung from it. We photograph any soft boards and show you before pricing that repair.
Gutter size and guards
Six-inch gutters and 3x4 downspouts cost more in material but move far more water. Guards add to the total, and the price varies by style.

Common gutter questions

Something not covered here? (919) 237-9586

How often do gutters need cleaning?

For most homes, two cleanings a year is enough: one in late spring and one once the trees are bare in late fall. If your home sits under thick pine or oak cover, a third visit may be worth it. Guards lengthen the gap between cleanings, but they still benefit from a periodic check.

Is it possible to fix my existing gutters rather than replace them?

In many cases it is. Corners that drip, hangers that have worked loose and runs with the wrong slope are all repairable. We only recommend new gutters when the metal has thinned, bent badly or rusted through, or when the system is undersized for the water your roof sends into it.

What is the advantage of one-piece gutters?

Sectional gutters have a seam roughly every ten feet, and each seam can eventually open up and drip. One-piece gutters are formed as a single length for each run, so joints appear only at the corners and outlets. The roofline also looks cleaner without the seams.

Are gutter guards worth it?

Guards cut down on cleanings considerably, though none of them remove upkeep entirely. Which style fits depends on the trees near your home. We will give you a straight answer on whether guards make sense or whether scheduled cleanings are the better use of your money.

Storm wind tore my gutters loose. Will you help with my insurance claim?

We will. We can meet the adjuster at your home and walk you through the claim process, providing our photos and measurements along the way. If the roof was damaged too, our storm damage repair work lets us look at both on the same visit.

Aerial view of a brick ranch home with a new charcoal asphalt shingle roof showing hips, roof vents, a brick chimney and white gutters in a wooded neighborhood

See how water leaves your roof

We will look over your gutters and the roof edge above them at no charge and send photos of everything we saw. The choice of what to do, if anything, stays with you.